en
ACCTIVA Professional
 |
Zoom
close
The universal battery charger
The little brother of ACCTIVA Professional Flash. Contains all the important features, with powerful 30 A for universal use in the workshop. The 5 pre-programmed charging characteristics guarantee the correct charging current for the size of the battery. The LC display clearly shows the most important charging condition parameters, e.g. current, voltage, charged Ampere hours, etc.
The little brother of ACCTIVA Professional Flash. Contains all the important features, with powerful 30 A for universal use in the workshop. The 5 pre-programmed charging characteristics guarantee the correct charging current for the size of the battery. The LC display clearly shows the most important charging condition parameters, e.g. current, voltage, charged Ampere hours, etc.
The product can be purchased via the following sales and service partners.
Recommended fields of use
Ideal for motor vehicle workshops and showrooms, commercial vehicles, motorcycles, buses, agricultural and construction machinery
Overview
Product information:
- Automatic preselection of battery voltage (6 V, 12 V and 24 V)
- For charging or charge conservation of conventional lead acid, lead calcium/silver batteries, or those of the sealant type (AGM, MF), as well as maintenance-free lead GEL batteries, without disconnecting from the vehicle power supply
- Max. 30 A charging current in all voltage ranges
- Compact design thanks to primary switched mode power electronics
- Based on Active Inverter Technology
Technical Data
| Nominal charging voltage | 6 - 12 - 24 V |
| Charging current | 0.6 – 30 A |
| Battery capacity | 2 - 300 Ah |
| Mains voltage | 230 V +/- 15 % |
| Charging characteristic | IUo U |
| Marks of conformity | CE / TÜV North America / TÜV SPE |
| Battery charger lead | 2.5 m with fully insulated charging terminals |
| Dimensions | 290 x 144 x 75 mm (L x W x H) |
| Weight | 2 kg |
Equipment features
Applications:
- Charging mode: Automatic charging with IUoU characteristic
- Trickle charging: Consumer loads switched on and in use during charging (powering demonstration vehicles in the showroom, etc.)
- Back-up mode/diagnosis: Back-up of vehicle power supplies without integral starter battery, buffering of vehicle power supply during diagnosis, voltage retention when changing the battery Conservation charging: After charging, automatic switchover to conservation charging
- Refresh mode: Low-power batteries can be recharged in this mode (decomposition of sulphate layer). This process takes place via a microprocessor-controlled IUIoU characteristic.
Protective features:
- Electronic reverse polarity protection
- Thermal overload protection
- Safety cut-out
- Electronically safe
- Short-circuit protection
